![]() Don’t charge the battery right after a flight because the battery’s temperature may be too high.Mavic Pro, Inspire 1 Series, Phantom 3 Series Follow the stated temperature for battery use.If the DJI GO app displays a warning that battery cells are abnormal or damaged, stop using the battery. Keep an eye out for app alerts during flight. Check the status of the battery in the DJI GO app after powering on the aircraft.Don’t remove or install the battery from the aircraft when it’s turned on.Do not allow the battery to come into contact with liquids.If a battery is idle for a long time, its performance might be affected. Read the Intelligent Flight Battery Safety Guidelines.Inspect the gimbal for damage and camera lens for dust or dirt.Make sure there are no bent blades or cracks. Check condition of propellers before and after every flight.Do not modify the structure of DJI products.Only use original or certified DJI accessories. Contact DJI Support if any damage is spotted. Inspect the outer shell and other components for damage.At a controlled low altitude, fly within range of any interference and recheck all controls and stability.Need some guidance for checking up your drone, maintaining battery health, transporting your drone properly etc.? This checklist can help you maintain your drone and avoid unnecessary failures as drone maintenance is key to your flight safety.If required by flight path walkthrough, verify any noted obstructions that may interfere with the drone.Verify all controller operations for heading and altitude.Start the drone propellers to inspect for any imbalance or irregular operation.Verify communication with the drone and that the drone has acquired GPS location from at least 4 satellites.Check that any equipment, such as a camera, is securely attached.Check battery levels for the aircraft and control station.Check fuel for the correct type and quantity.Check the flight termination system, if installed.Check onboard navigation and communication data links.Check for correct movement of control surfaces using the control station.Check that control link correct functionality is established between the aircraft and the control station.Check ground support equipment, including takeoff and landing systems, for proper operation.Check that the display panel, if used, is functioning properly.Inspect the control link transceiver, communication/navigation data link transceiver, and antennas.Calibrate drone compass prior to any flight. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |